Diagnosing dry-type transformer faults by identifying various abnormal sounds.


Time:

2026-08-07

Dry-type transformers may produce unusual noises. If the transformer's sound is louder than normal and has noticeable abnormalities, but the current and voltage are not significantly abnormal, it may be due to loose internal clamps or screws tightening the core, causing increased vibration of the silicon steel sheets.

Dry-type transformers normally operate without any noise, which is perfectly normal. However, sometimes a lot of noise can occur, indicating that a fault can be identified through sound. In fact, the sound of a dry-type transformer can reveal signs of damage. Generally, the following sound problems indicate a fault in a dry-type transformer, requiring repair. These common sound problems during operation indicate that your dry-type transformer is broken. Let's take a closer look:

Dry-type transformers may produce discharge sounds. If partial discharge occurs inside or on the surface of the transformer, the sound will be accompanied by a "crackling" discharge sound. When this occurs, if blue corona or sparks are visible near the transformer bushing at night or in rainy weather, it indicates severe contamination of the ceramic components or poor contact of the equipment clamps. If there is internal discharge within the transformer, it is due to electrostatic discharge from ungrounded components or poor contact in the tap changer. In this case, the transformer should be further inspected or shut down.

Dry-type transformers may make a boiling water sound. If the transformer's sound is mixed with the sound of boiling water and the temperature changes rapidly with a rise in oil level, it should be judged as a short circuit fault in the transformer windings or severe overheating of the tap changer due to poor contact. In this case, the transformer should be shut down immediately for inspection.

Dry-type transformers may make popping sounds. If the transformer's sound is mixed with uneven popping sounds, it indicates insulation breakdown inside or on the surface of the transformer. In this case, the transformer should be shut down immediately for inspection.

The above sound issues are a detail that cannot be ignored. Everyone should pay close attention to them, otherwise, the transformer will become truly unusable, not only resulting in poor performance of the dry-type transformer but also potentially shortening its service life!