Analysis of the iron core in a transformer
Time:
2026-08-07
The core is the fundamental component of a power transformer, composed of core laminations, insulation components, and core structural components. The core itself is made of magnetic steel strips with high permeability. To ensure that different windings induce voltages proportional to the number of turns, the magnetic flux linked between the two windings needs to be equal. This necessitates a core made of a material with high permeability within the windings, maximizing the amount of magnetic flux linked to both windings within the core and minimizing the amount linked to only one winding.
To reduce excitation current, the core is designed as a closed magnetic circuit. The core also serves as the frame for mounting the coils, making it an extremely important component for the transformer's electromagnetic performance, mechanical strength, and noise reduction.
The core laminations are formed by stacking or winding electrical magnetic steel strips. The core structural components mainly consist of clamps, pads, supports, tension straps, tension bolts, and pressure studs. These structural components ensure the laminations are fully clamped, forming a complete and robust core structure. Insulation components are present between the laminations, clamps, feet, support plates, and tension strips and tension plates. Grounding leads from the core laminations are connected to the clamps or reliably grounded externally via a mailbox; multiple grounding points are not permitted on the core. For large transformers, the lower clamps of the core are positioned using positioning pins on the mailbox, and positioning components on the upper support plates cooperate with the mailbox for positioning.
To reduce the transformer's no-load loss and no-load current, in addition to using high-permeability, grain-oriented cold-rolled electrical magnetic steel strips, the core also incorporates a series of structural measures, such as using a non-perforated, mitered core with oblique joints to accommodate the directionality of the cold-rolled, grain-oriented magnetic steel sheets and employing a magnetically symmetrical core structure.
The portion of the core covered by the windings is called the core column, and the portion not enclosed by the windings forming a closed magnetic flux path is called the yoke. The space defined by the core column and yoke is the core window, the size of which is related to the number and cross-sectional area of the windings.
Transformer cores are generally divided into two main categories: shell-type cores and core-type cores. Each type is further divided into stacked cores and wound cores. Stacked cores are made by stacking sheet-like electrical steel strips one by one; wound cores are made by continuously winding strip material using appropriately shaped dies on a winding machine. There are also double-frame cores, i.e., large and small frame structures, but nowadays, because high-quality cold-rolled electrical magnetic steel strips are used, the width of the strips is sufficient to meet the requirements of the core column and yoke width, so double-frame (large and small frame) cores are rarely used. In addition, there are newer double-frame and multi-frame structures, such as single-phase double-frame and three-phase four-frame structures.
If classified according to the number of phases, the cores of single-phase transformers are collectively called single-phase cores, and the cores of three-phase transformers are collectively called three-phase cores; they can also be classified according to the number of columns, frames, etc.




