How to reduce electromagnetic interference from transformers on amplifiers?
Time:
2026-08-07
Power transformers can interfere with amplifiers through magnetic fields, electromagnetic induction, and circuits, making them the biggest source of interference in audio equipment. Therefore, proper handling of their operating conditions and application environment is crucial to effectively avoid interference from power transformers and achieve excellent sound quality for the amplifier. I will discuss this further below.
1. Besides supplying power to the amplifier, the power transformer can couple the amplifier to the power supply, allowing interference from the mains grid to enter the amplifier, while also reflecting voltage and current changes generated by the amplifier back into the mains grid. To cut off the electrostatic field and capacitive coupling between the windings, isolate and suppress the resulting common-mode interference, and prevent common-mode voltage from the mains grid or circuit from coupling to the secondary or primary windings, it is critical to add Faraday electrostatic shielding to the windings of audio power transformers. This shielding can be alternating layers of copper foil or a complete composite structure; in short, the more the windings (especially the primary windings) are surrounded, the better the common-mode suppression.
2. Magnetic field interference generated by power transformers has always been a problem hindering amplifier quality improvement. Even with a clean power supply, the magnetic field induction from the transformer can severely degrade amplifier quality. Because magnetic shielding enclosures are expensive (even exceeding the price of the transformer itself, which explains the high price of some imported transformers), domestically produced machines rarely use them to cut off magnetic interference. Many simply use a plain iron cover for isolation, or even install the transformer exposed, thus failing to provide effective magnetic shielding. High-quality foreign transformers often employ a multi-layered structure of alternating manganese alloy and coarse copper layers to enclose the transformer. This utilizes the high resistance and high permeability of the manganese alloy for magnetic short-circuiting, and the eddy currents induced within the copper layers generate a magnetic field opposite to the interfering magnetic field to cancel out the interference, thus greatly reducing magnetic field leakage. While manganese alloy enclosures are difficult to obtain under amateur conditions, multi-layered magnetic shielding enclosures can be made using 1.5mm soft iron plates and copper plates.
3. When the primary impedance of the transformer equals the parallel value of the source resistance and the reflected resistance of the load, a low-frequency cutoff will occur, increasing noise originating from the transformer. Therefore, the power transformer must also have sufficient inductance. However, this should not be a reason to blindly increase the transformer's output power. Because the primary inductance of a transformer varies with the magnetic flux density of the core, a smaller secondary load power leads to a decrease in core magnetic flux density and thus a drop in inductance. Generally, the power rating of a power transformer should be selected between 1.4 and 2 times the secondary power supply power for optimal performance.
4. High-quality transformers have very high core permeability and magnetostriction, making them sensitive to external magnetic fields, pressure, and vibrations. This can generate additional voltage and cause interference. Therefore, the following measures should be taken during transformer assembly or installation:
The core or shield must be demagnetized before assembly.
Avoid short circuits in the core, which generate eddy currents, reduce magnetic flux, and decrease inductance.
The transformer should be vacuum-impregnated to prevent lamination from shifting.
The transformer should be installed on a vibration-damping base, and any magnetic field source should also be installed with vibration damping.
If installation space permits, the transformer should be acoustically isolated.
5. The type of transformer is also important for reducing interference. Generally, toroidal or O-type transformers are highly efficient and have low leakage flux,
but their magnetic flux is prone to saturation, which makes them less resistant to power grid interference. EI-type transformers, on the other hand, have the opposite effect, and because of the air gap, the permeability of the iron core is stable. R-type transformers fall somewhere in between. Due to the severe pollution of my country's power grid, many people prefer EI-type transformers for audio equipment power.
Recommend




